Test conditions for high accuracy turret and single spindle coordinate drilling and boring machines with table of fixed height with vertical spindle. Testing of the accuracy - Single column type machines1 Scope This part of ISO 3686 specifies, with reference to ISO 230 1; both geometric tests and machining tests on vertical spindle, single column type coordinate drilling and boring machines. It also specifies the applicable tolerances corresponding to the above mentioned tests. It should be noted that, besides drilling and boring operations, it may be possible to carry out light milling operations with these machines. However, this part of ISO 3686

BS EN IEC 61000‑6‑2 defines the immunity test requirements for equipment specified in the scope in relation to continuous and transient conducted and radiated disturbances

The procedure is applicable to any corrugating medium intended to be used

Who is BS 2068- Specification for acetic anhydride for

you can improve the standard of butt-welded cutting tools and blanks to manufacture a standardized product that has global acceptance in the market

BS EN 61067-1 is a part of the IEC 1067 series that specifies requirements for loomstate

Application of flow resistance factor KR

Who is BS EN 14149 - Impact test on packages by rotational drop for

BS EN 61120-1 is practical to have switchable operation between these two formats

Who is BS EN 13920-16 – Aluminium alloys for

PD 6689 gives guidance on the performance requirements and control procedures for the installation of both surface treatments as products for the maintenance of roads and other trafficked areas

BS 8549 will also enable you to identify the potential risks or possible threats for your operations

flange and threaded joints