Shrink chuck 4,5° HSK 50 - 05 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For horizontal clamping of flat workpieces

The fine-adjustment allows the slider to be precisely positioned

Strength class:

6 µm radial run-out with a 5 µm clamping nut

Without wrench

so the system is suitable for through-coolant feed

driving ring and feather key

DIN 1835 form A+B+E and DIN 6535 form HB+HE

Instructions for useWrench4 pcs

Clamping screw

prevents overfeeding

For tools with taper shanks DIN 69871 and JIS B 6339 (MAS-BT)