Milling arbors for screw-in cutters SK 40 - M10 - 94 - LB75Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

better chip evacuation

- with 2 connectors Ø 6 mm and Ø 8 mm

Plain clamping nut without grooves for high speed machining

Torque range : 20-110 Nm

With clamping screw and O-ring

- Tightness of the screw connection tested up to 80 bar

- Especially suitable fore wire EDM

T-nuts 18 mmTest certificate

For individual combination of T-bolts in conjunction with T-nuts and tenons

Wherever reduced interference contours are required

With coolant channels for optimal coolant at the cutting edge

- in case/box