Agricultural and forestry machinery. Environmental requirements for sprayers - General1 Scope This part of ISO 16119 specifies general requirements for the design and performance of sprayers, as defined in ISO 5681, with regard to minimizing the potential risk of environmental contamination during use, including misuse foreseeable by the manufacturer. It also specifies the requirements for identification of the sprayer and certain of its components, and the minimum content of the instruction handbook. It is intended to be used with

4)       Cranes permanently installed on marine and other water-borne vessels

BS 7254-5 is the fifth part of the multi-part series that outlines the requirements to produce castings made of cobalt-chromium-molybdenum alloy for use in the manufacture of surgical implants and ensures that necessary quality standards for castings made of cobalt-chromium-molybdenum alloy are achieved

BS 1982-2 discusses the fungal resistance of panel products

Correction of the valid failure zone limits and the use and reporting of data outside the valid zone

ISO 10540-1 is the reference (colorimetric) method for the determination of the phosphorus content in fats and oils

Suppliers of components for electric lamps

3 Trial tests

BS 8431:2010 Electrical static meters for secondary metering and sub-metering

Manufacturers and suppliers of non-active surgical implants

Top hung and side hung fully reversible

Vehicle classifications – Illustrations

The KDM is based on the D-Cinema generic Extra-Theater Message (ETM) format [ЕТМ]