Road vehicles. Elastomeric cups and seals for cylinders for hydraulic braking systems using a non-petroleum base hydraulic brake fluid (Service temperature 120°C max.)1 Scope This International Standard specifies performance tests of brake cups and seals for hydraulic braking systems for road vehicles; it does not include requirements relating to chemical composition, tensile strength and elongation of the rubber compound. Disc brake seals are not covered by this International Standard. This International Standard is applicable to moulded seals (cups or double lipped type gland seals), 60 mm in diameter and

Different types of test specimens and test conditions are defined

PD 6682-8:2004 provides guidance on the use of BS EN 13450 in the UK

Anyone involved in commissioning

designed in accordance with EN 13480-3

8 kg/m (50 lb/yd) or greater linear mass

BS 2556 on hand drills and breast drill specifications is useful for:

This Recommendation | International Standard provides the specification of management information within an Open System related to those operations of the OSI Network Layer

BS 5760-10

Application of quality assessment procedures

These amplifiers can receive and possibly respond to such commands by using resident firmware or may be optical amplifiers controlled by a microprocessor

Part 9: Wrought high nitrogen stainless steel

Setting of the output level at the EUT port of the coupling device