Mechanical fasteners for gypsum plasterboard systems. Definitions, requirements and test methods1 Scope This European Standard specifies the characteristics and performance of mechanical fasteners, including nails, screws and staples, intended to be used for the fixing of gypsum plasterboard, gypsum boards with fibrous reinforcement, products from secondary processing and suitable ancillary products as shown in Figure 2, to timber and metal, as appropriate, in building construction works. The fasteners secure the board to the framing enabling

Manufacturers of abdominal physiological parameter detectors

This system enables each vehicle manufacturer to support all vehicle communication interfaces to perform diagnostics and to control the programming sequence for electronic control units (ECUs) in their vehicles

fabrics may be tested accordingly to BS 5438 both before and after being subjected to the procedures specified in the present standard

Security aspects of how and where the vehicle is left are also considered

by end-of-line of automotive and exhaust parts manufacturers

Why should you use BS EN 569 - Safety requirements for pitons

Has been restructured and prepared to reflect changes in legislation and coating material technology

Why should you use BS EN IEC 60122‑4 - Quartz crystal units of assessed quality

Transporters of concrete

This part of ISO 5361 specifies general requirements for Cole tubes for use in infants

BS 7533-13 gives guidance on the design of permeable pavements surfaced with:

which gives them the freedom to design various shapes and appearances