Specification for binding and identification sleeves for use on electric cables and wires1 Scope This British Standard specifies requirements and tests for binding and identification sleeves intended for use on electric cables and insulated wires. NOTE These sleeves are not for use as primary insulation The standard applies to sleeves of the following types: a) type 1 sleeves are polychloroprene and suitable for temperature ranges of 65 C to 70 C; b) type 3 sleeves are poly(vinyl chloride) (PVC) and suitable for temperature ranges of 65 C

This document specifies the necessary information required in a report of analytical results based on measurements of the intensities of peaks in Auger electron and X-ray photoelectron spectra

2 Test power spectral densities (PSD)

The scope has been expanded to include steel slags

NOTE: A standard exists providing general requirements for the validation and control of dry heat sterilization processes (see ISO 20857)

for applications where collision resistance is not required

BS 17065:2012 provides insight into legal and contractual matters

Other topics include calibration procedures and measurement uncertainty

suppliers and users of medical electronic equipment and components relating to alarms and alarm systems

This British Standard

hole drilled through steel girder

ISO 11137:1995

Contractors – specialist anchor contractors