Cast iron pipes and fittings, their joints and accessories for the evacuation of water from buildings. Requirements, test methods and quality assurance1 Scope This European Standard applies to cast iron pipeline components used for the construction of discharge systems for buildings and of drains, normally as gravity systems. The range of nominal sizes extends from DN 40 to DN 600 inclusive. This standard specifies the requirements for the materials, dimensions and tolerances, mechanical properties, appearance, standard coatings for cast ironpipes, fittings and accessories. It also indicates

b) References to non-contradictory complementary information (see NA

Mechanical laboratories

because this type of certification is specific to local jurisdictions

The test detailed in this standard shall then be conducted under normal ambient conditions

It also specifies the methods for determining the vibration emission transmitted to the whole body of drivers standing and/or seated on freely moveable GSE

either cyclically or acyclically

The primary objective of surface preparation is to ensure the removal of deleterious matter and to obtain a surface that permits satisfactory adhesion of the priming paint to steel

construction and engineering industries

precedence over any EN covering the same scope but with a wider

BS EN IEC 60317-25:2020 supersedes BS EN 60317‑25:2010

the quality models in ISO/IEC 25010 and ISO/IEC 25012 are used to categorize quality requirements and to provide a basis for quantifying them in terms of quality measures in the quality measure division of ISO/IEC 2502n

or any combination of these