Test conditions for machining centres - Evaluation of thermal distortions1 Scope This part of ISO 10791 specifies, with reference to ISO 230 3, tests for the evaluation of thermal distortions of the machine structure and positioning system, up to 2 000 mm in length, of machining centres. It gives three test methods: environmental temperature variation error; thermal distortion caused by a rotating spindle; thermal distortion caused by moving linear axes. There is no intention of assigning any numerical tolerances

special means against water vapour diffusion and water accumulation by air flow might be required

which incorporates the Plan-Do-Check-Act (PDCA) cycle and risk-based thinking

What is ISO 4064-4 – Non-metrological requirements of water meters about

are a key element for electronic products

Although the information on racking resistance given in this Section of BS 5268 is restricted to wall panels no greater in height than 2

This is Part 2 in a short series of British Standards giving topic-specific guidance on using the international occupational health and safety management system standard BS ISO 45001

General requirements for bodies operating product certification systems

PD CEN/TS 17241 specifies system status and fault information (particularly for the sub-systems in the field level) to help the users  support system monitoring and fault clearance

Test centres and calibration laboratories

BS 7074-3 descriptively discusses

ISO 1818:1975

In the process of electrostatic flock application