HB612R Bronze Helical GearBoston Gears stock helical gears are manufactured in both right and left handed configurations with an industry standard 45 helix angle to transmit motion and power between non intersecting shafts that are parallel or at 90 to each other. For parallel shaft operation, helical gears with opposite hand helix angles are required. For shafts at 90, a same hand helix angles must be used. For parallel shaft applications, the overlapping tooth contact of our

Standard Paint

Mounted component remains fixed axially during installation

Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor

Just ask your CSR which is best for you

The spline design virtually elimi nates back lash which is a delayed action effect caused by excessive clearances between hub and discs

Click here for spec sheet: HUCFL Spec Sheet

and cast iron and are manufactured in a variety of styles

Click here for spec sheets: SUCTPA Spec Sheet

Two-Piece Housing has rust-proof plated finish

As a result

Acetal Copolymer collars will not rust or corrode

Material: Molded Delrin