Plastics. Preparation of test specimens of thermoplastic materials using mouldless technologies - General principles, and laser sintering of test specimens1 Scope This part of ISO 27547 specifies the general principles of test specimen preparation using mouldless techniques. Sometimes, these techniques are called tool less methods. Common to all these techniques is the fact that the specimens are produced layer by layer. The shape and dimensions of the specimens are defined in terms of a numerical description using CAD techniques. This computer model of the specimen is sliced into layers by means of

BS EN 1198 helps you to avoid potential adverse effects on the quality of water intended for human consumption

This document specifies requirements for:

BS EN 13184 provides users guidance on personnel qualifications

this should be done for specific outcomes

Metallic materials - Bend test

It must be ensured that the risk of financial loss is reduced through the appropriate use of cryptographic devices that have proper physical and logical security characteristics and are properly managed

Definitions of the admittances to be measured

Load test set-up for CTS/CDS in accordance with 10

BS 6381 specifies requirements for drawing boards

Direct connected and transformer operated meters

Why should you use BS EN 14395-1 - Influence of organic materials on water

The following categories of water heating or steam-raising plant are covered: