Milling arbors for screw-in cutters SK 40 - M16 - 94 - LB75Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

5-30mm and 25-50mm range are supplied with setting rings

For sealing tools with internal cooling in collet chucks

Only nominal size d can be clamped (applicable up to 120 bar)

Delivery: without inserts

For attaching shell-type milling cutters

a clip and can be moved in steps of 25 mm

- with 2 connectors Ø 6 mm and Ø 8 mm

Inch/Metric conversion

For face machining

contact- and hot air shrink units

Functional parts hardened and ground

- The steel body is hardened and grinded all-round