Industrial furnaces and associated processing equipment. Safety - General requirements1 Scope This document specifies the general safety requirements common to industrial furnaces and associated processing equipment (TPE). This document deals with the significant hazards, hazardous situations or hazardous events relevant to TPE, as listed in Annex A, when TPE is used as intended and also under conditions of misuse that are reasonably foreseeable by the manufacturer. Annex B provides a list of common industrial furnaces and associated

the design indoor (room) temperature (TR) as well as the balance point or heating limit temperature (TBP) for three heating seasons (climatic conditions)

Organisations that want to improve or implement an energy management system

BS EN 12217 is applicable to hinged/pivoted and sliding door sets with latches

and also allow for inspection

(1) Part 2 of Eurocode 4 gives design rules for steel-concrete composite bridges or members of bridges

Note: The method outlined in BS EN 12788 should not be used to obtain values of flexural strength for design purposes

testing and inspection of site built

BS EN 62665 on texture map for auditory presentation of printed texts is useful for:

and of a maximum hardness of 82 HR30TSm or 93 HR15TSm

This document specifies a method for the dynamic preparation of calibration gas mixtures containing at least two gases (usually one of them is a complementary gas) from pure gases or gas pre-mixtures using critical flow orifices systems

NOTE These issues will be addressed in IEC/TS 62351‑91

Implementation and operation