Rolling bearings. Accessories - Dimensions for locknuts and locking devices1 Scope This part of ISO 2982 specifies: dimensions of locknuts; runout tolerance of locknut clamp face with respect to pitch diameter of screw thread; dimensions of lockwashers with straight inner tab for use with 4 slot locknuts; dimensions of locking clip assemblies for use with 8 slot locknuts. The locknuts are also suitable for axial location of bearing inner rings on shafts and for dismounting of withdrawal sleeves. For adapter sleeve assemblies

testing being carried out under such conditions that the fluid permeability can be expressed in terms of viscous and inertia permeability coefficients

What is BS 2782-3: Method 360C - Determination of the tear resistance of flexible unsupported plastics film about

Changes in BS 2893:1989 include:

United Kingdom and Zambia

This document specifies several methods for measuring the oxide thickness at the surfaces of (100) and (111) silicon wafers as an equivalent thickness of silicon dioxide when measured using X-ray photoelectron spectroscopy

Webbing width and thickness

BS EN 4540 specifies the required characteristics

Computer programmers

Distribution service

Peer-to-peer lending platforms

channel parameter data type

Who is BS EN 61221 - Triaryl phosphate ester turbine control fluids for