Electronic cigarettes and e-liquids. Constituents to be measured in the aerosol of vaping products1 Scope This document gives a list of constituents of interest proposed for measurement in the aerosol for the purpose of regulatory submission under the Directive 2014 40 EU (TPD) [2], for prefilled products such as disposable e cigarettes and refill cartridges, e liquids sold in refill containers, the following categories of hardware: coils or other heater elements of the vaping product, atomisers, rebuildable atomisers and all open tank or dripper

e) suitability of equipment and its accessibility for cleaning

BS 978-3 provides for Class A gears for use where a high degree of accuracy is required

BS EN 13205-2 provides guidance on the use of commonly used devices for the detection of airborne particle concentrations in the workplace air

to comply with the European chemical regulations and recommendations in force in the EU

2 on intruder alarm systems is relevant to:

Where development

Introduction of the class Gazetteer to replace the class SI_Gazetteer

BS EN 1717 specifies the minimum requirements for product standards of protection units

experienced

this analysis and representation can identify where capabilities that are needed to achieve desired higher levels of interoperability are insufficient and consequently investment or reengineering is required (TO-BE)

This International Standard specifies an optical method for the determination of dissolved oxygen in water using a sensor working on the basis of fluorescence quenching

PD IEC/TR 60870-6-505 on TASE