Shrink chuck 4,5° BT 40 - 16 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For adaption from ISO40 to PSC (ISO 7388-1 to ISO 26623-1)

Hardened and grinded all around

For the coolant supply through the centre of PSK toolholders

- Repeating accuracy 0

Battery :1

From d = 25 on two clamping screws

Collets sealed with seal for IC

6 T-slot nuts

T-nuts 18 mm

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

With clamping screw

Adaptive interface machine direction (ADINTMS): BMT non-driven turret interface -size BT65A