Tools for moulding. Centring sleeves1 Scope This International Standard specifies the dimensions and tolerances, in millimetres, for centring sleeves intended to be used for locating the spacing blocks in relation to the fixed clamp plates in moulds. It gives indications concerning materials and hardness, and specifies the designation of centring sleeves which meet the requirements of this International Standard.

BS AU 200-1a on the design of containment devices is useful for:

This part of IEC 61300 details a procedure for determining the suitability of a fibre optic device to withstand the environmental condition of high humidity and high temperature which may occur in actual use

2 How to deal with special values

This standard is an open

but not including steppers

A detailed analysis of the main uncertainty contributions for single and for repeated measurements is shown

such as technical drawings

dynamic risers or those constructed from other materials

BS EN 15265:2007 - Energy performance of buildings

Personnel responsible for software development and quality assurance

Sometimes the life of a product is significantly shorter simply because of poor weld quality

The aim of this part of IEC 61000 is to present a methodology to assess the impact of High-altitude Electromagnetic Pulse (HEMP) and High Power Electromagnetic (HPEM) environments on electronic systems