Fasteners. Acceptance inspection1 Scope This document specifies an inspection procedure to be used by the purchaser where no prior agreement exists. It also specifies a reference acceptance procedure for acceptance or rejection of an inspection lot, when no agreement can be reached between the purchaser and the supplier, or where conformance to specification is disputed. It applies to inspection lots of bolts, screws, studs, nuts, pins, washers, rivets and other related fasteners.

It selects from the generic specification

assessment of trueness and measurements of the unknown samples

Guidance on BS EN 806-5

in conjunction with the order

the communication between the interrogator and the sensor(s) is always through the RFID tag

this part of ISO/TR 14999 outlines the basic configurations for two-beam interference

it updates aspects of:

BS EN 12195-4 is the fourth part of the BS EN 12195 series that specifies safety requirements for lashing steel wire ropes and flat lashing steel wire ropes and lashing combinations with lashing steel wire ropes for the safe surface transport of loads on load carriers

It also establishes a system for the scheduling of reinforced bars

BS EN 71-1 Matters to consumers because unsafe toys could put millions of UK children at risk of accident

global consideration

This code of practice does not apply to roofs with self-supporting coverings