Fresh Air Switching ValveAbout: The ZD179 1 valve block is a four port, two state design allowing a single air feed to be switched between two outlet ports with an exhaust to atmosphere. This can power both sides of a pneumatic actuator or switch air flow in turbo control applications. The switching control valves feature a rapid response time and high flow rates. An inline design allows for streamlined packaging and installation. The CNC machined block has a black anodised

Replacement filters also available separately under ZL015-1

while at the same time eliminating the possibility of paddle bounce or any phantom shift requests

- Speed signal capability on all inputs

and has also been successfully used in WRC and off road race cars

Bespoke software and configuration can support individual requirements such as fail safe protocols

Bite point can be optimised with a clutch position to paddle demand calibration table allowing full control over the paddle map

- Available with DTM or Auto-sport connector

A large water jet cut carbon pad allows easy operation of the paddle from a range of steering wheel positions

manual and wiring details

- 1KHz sampling frequency rate

Pro-Motorsport Wiring Loom - GCU800 Loom

- Valve on actuator design