Triumph clutch hub puller 61-7014This clutch hub puller is a necessary tool when working on your clutch to remove the clutch hub. It has 1" diameter thread with 20 threads per inch, please make sure this is correct for your application. This is also the correct tool to pull the fixed gear on some Triumph pre unit Lucas magnetos. Please check that it is a 1" 20TPI, as some fiber gears had different threads. This is Triumph part number 61 7014, and also supersedes 60 1861, 60 0662, and

Nothing even comes close in terms of longevity

and have been proven to be superior to anything available in fit or function

This fits pre unit swingarm frame Triumph 500 and 650 models with alternator only (will not fit dynamo equipped models)

Any residual gasket that is squeezed out can then be cleaned off with acetone

70-3309 SHIFTER O RING x1

(Don't be fooled by all the "screened" stacks

Made in England

When in doubt it is always a good idea to replace them with new and high quality seals

This beehive spring kit for the Triumph 650 is not just for racing

They will also work on all Triumph Bonnevilles up to 1978 with minor adjustments

allowing a lower cost over titanium retainers

If you are building a Triumph 650 twin or rebuilding a head