Tools for moulding. Sprue pullers1 Scope This International Standard specifies the main dimensions and tolerances, in millimetres, of sprue pullers, which are used mainly in injection moulds for plastics and rubbers. See the example of application in Figure 1. It also specifies the material, hardness and designation of sprue pullers conforming to this International Standard. Figure 1 Application example of sprue pullers 1 ejector pin (ISO 6751) 2 sprue puller (ISO 16915) 3 locating

5 Dimensions and tolerances

It now reflects industry best practice

Transport Wales

Recommendations of any specific tools

and length of matched sets for various types of slings such as Single-leg slings

it is vital to take into consideration best industry specifications when manufacturing control cable assemblies

With BS 3962-6 you can be ensured that the products consistently meet and exceed quality assurance targets

This version of BS 5974 is a full revision of the standard

the five types differing in their pressure ratings and volumetric expansion

Guidance on the acquisition of data for measuring and describing environmental noise relevant to general land use

NOTE: The recommendations is this standard are not intended to apply to the construction of shafts or tunnels for the purpose of mineral extraction

introducing new precision in a number of areas such as “Vehicle types”