Rear Crossmember Insert, US Made, 1950-1964, Willys Jeep CJ3A, CJ3B, CJ5, CJ6, FCNew reproduction steel rear crossmember insert and made in the USA. This insert fits between the frame rails behind the bumper crossmember. These are heavy duty construction and made from 12 gauge steel. These are bare metal and will need to be painted. Comes pre drilled for an easy installation. Typically these were used on Jeeps with PTOs but these are a great idea for adding strength to the rear crossmember. Fits: 1949 1953 Willys Jeep CJ 3A 1953

SCREW-TEK HEX SELF DRILLING W/NEO #10- 16 X 1 / 722546

specifically near the windshield

After Serial #199079

1981-1985 CJ-8

Brand new reproduction temperature gauge

vent and a travel cap

the original push-pull steering setup found on early CJ-2A

New replacement two groove water pump for the 4-134 F-head engine

Replaces the MZ-4113 or MZ-4199 or any starter that uses the 97 tooth ring gear

Verify application before ordering

and some have suggested this is the reason the vehicle wasnick-named the "Jeep"

much of the paper has disintegrated