Alpha HSS Tap Set MC-8x1.25 MCHS080Alpha Tap Sets contain a Taper, Inter and Bottoming tap. TAPER taps have a lead of eight threads and are used as a starting tap in difficult or high precision holes. Alpha Taper taps can be identified by the single ring on the shaft near the driving square. INTERMEDIATE taps have a lead of four threads and are used in most general purpose applications. Alpha Intermediate taps can be identified by the two rings on the shaft near the driving square.

medium-hard and hard wire

1/16" x 14 x 90mm

Compatible with CGA600/BOM Trade Map gas cylinders

Stainless Steel Hex Screws and Nuts ¼” x ¾” Set of 8

Courier Drivers

Anti flare flame

Stainless Steel Countersunk Screws and Nuts 3/16” x 1-1/4” Set of 6

M2 HSS Fully ground M2 HSS material increases drill life

shrink or block systemsProvides an instant low pressure sealThixotropic and high/very high viscosityUL approved

1 x Pkt of 100 Blue Colored Cable Ties - 200mm x 4

This threadlocker secures and seal bolts

• Heavy Duty Fan